Boot:
The positive and negative poles can be turned on when they are connected to the power supply.
Indicator light description:
Orange light flashing slowly: no signal;
Orange light is always on: signal reception is normal;
Orange light flashes quickly: Binding is in progress.
Binding method:
Turn off the remote control, press the link button on the receiver, the orange light will flash
quickly, indicating that the receiver is in the link mode, as shown in the figure below, then turn
on the remote control, the orange light on the receiver will become solid, and the receiver is
receiving signals normally .
Detailed description
Aisle1
Aisle2
Aisle3
Aisle4
Aisle5
Aisle6
14 milliseconds
Contact frequency
PWM signal:
The high level is 3.3V, a cycle of 14ms, and the output pulse width is 1000-2000us when it is not mixed, and it can reach
880-2120 when it is mixed or fine-tuned, as shown in the figure below.
To Next Page
Loading...
