Need help?Do you have a question about the Microzone MC6C and is the answer not in the manual?
Explains how to power the MC6C transmitter using batteries or external supply.
Describes the initial binding process required between the transmitter and receiver.
Details the sequence of lights and sounds upon turning on the remote control.
Provides instructions on safely powering off the remote control and receiver.
Explains the meaning of different LED states for power and signal status.
Outlines the initial steps for calibrating the transmitter's joysticks.
Details the signal range and number of channels for the transmitter.
Explains left-handed and right-handed modes for joystick configuration.
Describes the dual-rate (DR) switch for adjusting control surface sensitivity.
Details the function of trim switches and servo reverse settings.
Explains the V-tail and elevon mixing functions controlled by a switch.
Describes the structure and data format of the PPM simulator signal.
Explains how to use the trainer function with a second remote control.
Describes the function to prevent accidental adjustment of trims.
Explains receiver power-up sequence and LED status indicators.
Details the procedure for binding the receiver to the transmitter.
Describes the characteristics of the PWM signal output by the receiver.
Explains how the receiver behaves when the signal is lost.
Details the SBUS serial communication protocol and its requirements.
General| Brand | Microzone |
|---|---|
| Model | MC6C |
| Category | Remote Control |
| Channels | 6 |
| Power | 10mW |
| Display | LCD |
To Next Page
