Microzone MC6C - Detailed Description of Transmitter; Powering the Transmitter; First Time Use Procedures; Transmitter Start Up Sequence

First time use:
When you use the remote controller for the first time, you need to bind with the receiver. Please refer to the description of the
receiver below for the method of frequency binding. The same remote controller and the same receiver only need to be bound
once. The transmitter can control multiple receivers at the same time, and the receiver is only controlled by the remote controller
that is bound to the frequency.
Start up:
Push up the power switch to turn it on, the orange light and blue light are on at the same time, the horn beeps twice, and the
remote control turns on normally.
Powered by:
DC4-9V, You can use 4 AAA batteries to install in the
battery compartment, as shown in the figure below，
You can also use an external power supply to connect to the DC power socket on the right side of the remote control. When
using an external power supply, please remove the battery in the battery compartment first, as shown in the figure below.
Detailed description