Then pull the joystick to the middle position, as shown in the figure below, and finally pull the D/R switch to complete the
calibration.
At the same time, turn on the power of the remote control, enter the joystick calibration state, first move the two joysticks of the
remote control to the maximum, left and right, as shown in the figure below,
Versions after 2023: Pull the left joystick to the upper right corner, and pull the right joystick to the upper left corner, as shown below,
To switch between left and right:
Note: Recalibration is required for switching the left and right hand sticks;
Versions before 2023:
Remove the back cover of the remote controller, and replace the retaining springs and
neutral levers of the left and right joysticks, as shown in the figure below.
To Next Page
Loading...
