To assign a channel to a VCA fader or the automute system, the automation system must be
unlocked and the correct assign mode selected (VCA or Mute).
Select the desired automute or VCA using the assign keys (see above) and press the channel SET key.
The channel SET key can be used in two ways:
- A long press will erase the previous VCA or automute settings for the channel and take the new
setting given by the assign keys.
- A short press will not erase the previous VCA or automute settings for the channel. Instead, the
selected assign keys will toggle the assigns for the channel.
Long Press
Short Press
Input FaderInput Fader
set
input fader
10
10
5
5
0
20
30
40
50
70
dB
solo
1
2
3
4
5
6
7
8
9
10
set
safe’s
MUTE
FDR
AUTO
EG:
VCA 1,2,3 and 4 are already assigned to a channel
VCA 2 and 5 are selected on the assign keys
The channel select key is [short] pressed
Steps:
Result:
The channel will now be additionally assigned to VCA 5
The channel’s assignment to VCA 2 will be toggled
i.e. The channel will now have VCA assignments to
1,3,4 and 5.
Operators Manual- Page 22
To Next Page
Loading...
