Middle Atlantic Products UPS-2200R-8IP User Manual (English)

Questions and Answers:

J
Jaclyn StewartAug 9, 2025
What to do if Middle Atlantic Products UPS-2200R-8IP outlets do not provide power?
- B
  Brian MayAug 9, 2025
  If the outlets on your Middle Atlantic Products Power Supply aren't providing power, several issues could be the cause. First, a circuit breaker might have tripped due to an overload. To resolve this, turn off the UPS, unplug a piece of equipment, wait 10 seconds, reset the circuit breaker, and then turn the UPS back on. Second, the batteries might be discharged; in this case, recharge the unit for at least 4 hours. Also, if non-critical outlets have turned off automatically due to an overload, push the bottom Reset button to turn them back on. If the unit was damaged by a surge or spike, contact Middle Atlantic Products at 1-800-266-7225.
H
Heidi AyalaAug 16, 2025
Why Middle Atlantic Products UPS-2200R-8IP Power Supply UPS will not turn on?
- R
  Randy ReyesAug 16, 2025
  If your Middle Atlantic Products Power Supply UPS won't turn on, there are several potential reasons. The on/off switch is designed to prevent damage from rapid cycling, so turn the UPS off, wait 10 seconds, and then try turning it on again. Ensure the UPS is connected to a 110/120V outlet. If the battery is degraded or there is a mechanical problem, contact Middle Atlantic Products at 1-800-266-7225.
A
Aaron BrownAug 25, 2025
Why Middle Atlantic Products UPS-2200R-8IP UPS does not perform the expected runtime?
- S
  Selena MahoneyAug 25, 2025
  If your Middle Atlantic Products Power Supply UPS isn't providing the expected runtime, the battery may not be fully charged. Recharge it by leaving the UPS plugged in. If the battery is degraded, contact Middle Atlantic Products about replacement batteries at 1-800-266-7225.
D
Danielle SimmonsAug 31, 2025
How to fix inactive Middle Atlantic Power Manager software for Power Supply?
- L
  Levi BlanchardAug 31, 2025
  If the Middle Atlantic Power Manager software is inactive, first check that the serial or USB cable is correctly connected to both the UPS and the computer, ensuring it's plugged into the correct port and that you're using the cable that came with the UPS. If the unit is not providing battery power, shut down your computer, turn the UPS off, wait 10 seconds, and then turn it back on to reset the unit. Make sure that you use the cable included with the unit for the software.