Please check the following points before asking others for inspection or maintenance.
Faults Fault description
The product cannot be
normally operated after
being installed.
The air volume is
getting smaller.
Abnormalities of cool
wind function.
The power cord fails to be plugged in or has bad
contacts.
The machine switch fails to be opened.
The wet curtain is dirty, and should be cleaned on a
regular basis.
Check whether the water tank lacks water.
Troubleshooting
SERVICE GUIDE
MAINTENANCE INSTRUCTION
CLEANING
The fan requires little maintenance. Do not try to fix it by yourself. Refer it to qualified service
personnel if service is needed.
1. Before cleaning and assembling, fan must be unplugged.
2. To ensure adequate air circulation to the motor, keep vents at the rear of the motor free of
dust. Do not disassemble the fan to remove dust.
3. Please wipe the exterior parts with a soft cloth soaking a mild detergent.
4. Do not use any abrasive detergent or solvents to avoid scratching the surface.
Do not use any of the following as a cleaner: gasoline, thinner.
5. Do not allow water or any other liquid into the motor housing or interior parts.
1. Be sure to unplug from the electrical supply source before cleaning.
2. Plastic parts should be cleaned with a soft cloth moisten with mild soap. Thoroughly remove
soap film with dry cloth.
10
To Previous Page
Loading...
