37
The horizontal angle of the airflow must be set
manually. Grip the deflector rod (See Fig.B) and
manually adjust it to your preferred direction. For
some units, the horizontal angle of the airflow
can be set by remote control. please refer to the
Remote Control Manual.
Fig. B
Setting horizontal angle of air flow(Manual operation)
Do not put your fingers in or near the blowerand suction side of the unit. The high-speed fan
inside the unit may cause injury.
NOTE ON LOUVER ANGLES
●
Do not set louver at too vertical an angle for long periods of time
When using COOL or DRY mode. It would be condense the water
on the louver blade, which will drop on your floor or furnishings.
●
Setting the louver at too small an angle when using COOL or HEAT
mode, can reduce the performance of the AC due to restricted
air flow.
Setting Angle of Air Flow
CAUTION
While the unit is on, use the SWING/DIRECT button on remote control to set the direction (vertical
angle) of airflow. Please refer to the Remote Control operationl for details.
NOTE
: Setting vertical angle of air flow(Remote control)
Deflector rod
Do not move louver by hand. You can turn o the unit and unplug it for a few seconds to restart
the unit. It will be reset the louver when you try.
NOTE
●
According to the relative standards requirement, please sets the
vertical air flow louver to its maximum angle under heating
capacity test.
Heating
Capacity
Test
To Next Page
Loading...
Need help?
General
