47
SHORT CUT function
SLEEP function
Used to restore the current settings or
resume previous settings.
Push this button when remote controller is on, the system will automatically revert back to the
previous settings including operating mode, setting temperature, fan speed level and sleep
feature(if activated).
If pushing more than 2 seconds, the system will automatically restore the current operation
settings including operating mode, setting temperature, fan speed level and sleep feature (if activated ).
The SLEEP function is used to decrease energy use while you sleep (and don t need
the same temperature settings to stay comfortable). This function can only be
activated via remote control.
The sleep function is not available in Fan or Dry mode.Please refer to the OWNER’S
MANUAL for more details.
FP function
O
OO
O
O
Keep pressing Fan button for more than 2 seconds to activate/disable Silence function.
Due to low frequency operation of compressor, it may result in insucient cooling and
heating capacity. Press ON/OFF, Mode, Sleep, Turbo or Clean button while operating
will cancel silence function.
Silence function
Press this button 2 times during one second under HEAT Mode with setting temperature of 17 C/62 F or
20 C (for model RG10B10(B)/BGEF) to activate the FP function.
The unit will operate at high fan speed (while compressor on) with temperature
automatically set to 8 C/46 F.
2
2s
Press On/O, Sleep, Mode, Fan and Temp. button while operating will cancel this
function.
To Next Page
Loading...
Need help?
General
