9
7) Push water inlet tube into small hole on back of refrigerator. Rotate while inserng tube unl
flat surface of inlet tube is ght against back of refrigerator.
8) Push plasc water supply tubing (3) into water inlet tube (11) as far as it will go and finger
ghten nylon compression nut onto threaded end of inlet tube. Tighten another one half turn
with a wrench. DO NOT over ghten.
9) Install adjustable leveling bracket (7) on boom of ice ma
ker with screw (6). DO NOT ghten
bracket. (Bracket will be ghtened later.)
10) Start two, long, ice maker mounng screws (5) into freezer wall. Turn each screw five turns
clockwise.
To Next Page
Loading...
