10
11) With ice maker in one hand, plug ice maker connector into connector mounted on top
freezer panel. Make sure connecon is ght.
12) Mount ice maker onto two screws (5) you installedn Step 12. Tighten screws. Make sure water
inlet tube (11) is sing inside fill cup.
13) Adjust leveling bracket (7) to level ice maker (1). Ice maker is level when gap between freezer
wall and ice maker is same at top and boom. Tighten screw(6) when level.
14
) Reinstall freezer shelf in lower posion. Set ice container (2) on shelf.
15) Locate factory punched holes at boom right corner of rear panel. Holes are only drilled
To Next Page
Loading...
