12
ECO function
FP function
LOCK function
Under cooling mode, press this button, the remote controller will adjust the temperature
automatically to 24 C/75 F, fan speed of Auto to save energy (only when the set temperature
is less than 24 C/75 F). If the set temperature is above 24 C/75 F, press the ECO button,
the fan speed will change to Auto, the set temperature will remain unchanged.
NOTE:
Pressing the ECO button, or modifying the mode or adjusting the set temperature to less
than 24 C/75 F will stop ECO operation.
Under ECO operation, the set tmeperature should be 24 C/75 F or above, it may result in
insufficient cooling. If you feel uncomfortable, just press the ECO button again to stop it.
O
O
O
O
O
O
O
O
O
O
Clean
Press ECO button to enter the energy efficient mode.
Note:This function is only available under COOL mode.
ECO operation:
5s
5s
Turbo
The unit will operate at high fan speed (while
compressor on) with temperature automatically
set to 8 C/46 F.
Note: This function is for heat pump air conditioner only.
2
+
Press together Clean button and Turbo button at the
same time more than 5 seconds to activate Lock function.
All buttons will not response except pressing these two
buttons for two seconds again to disable locking.
Press ECO button(some units)
Press this button 2 times during one second under HEAT Mode and setting temperature of
17 C/62 F or 20 C/68 F(for models RG10B10(D)/BGEF, RG10A11(D)/BGEF) to activate FP
function.
Press On/Off, Sleep, Mode, Fan and Temp. button while operating will cancel this function.
To Next Page
Loading...
Need help?
General
