To Next PageTo Next Page
Need help?Do you have a question about the Midea Split Duct Air Conditioner and is the answer not in the manual?
General| Brand | Midea |
|---|---|
| Model | Split Duct Air Conditioner |
| Category | Air Conditioner |
| Language | English |
Requirements for the indoor unit's installation location.
Requirements for the outdoor unit's installation location.
Steps to install $10 hanging screw bolts for mounting the indoor unit.
Method for installing the unit on original concrete brick structures.
Method for installing the unit on steel roof beam structures.
Instructions for hanging and leveling the indoor unit.
Procedures for installing the main body and dust proof/air passage.
Details on positioning ceiling holes and indoor units with hanging screw bolts.
Method for installing in sites with limited space or access.
Detailed steps for maintaining the motor assembly.
Specifies required clearance for maintenance around the unit.
Instructions to cover pipes to prevent contamination during installation.
Essential considerations for connecting air ducts to the unit.
Table of applicable static pressure ranges for different unit capacities.
Steps for installing the unit's outer panels.
Detailed step-by-step guide for connecting refrigerant pipes.
Guidelines and restrictions for bending refrigerant pipes.
Methods to check refrigerant pipe joints for leaks.
Instructions for insulating pipes to prevent condensation.
Procedure for removing air from the refrigerant lines.
Proper torque for fastening nuts on refrigerant pipe connections.
Calculation and addition of refrigerant based on pipe length.
Using a vacuum pump to remove air and moisture.
Steps and considerations for installing the drain pipe.
Power requirements and wiring specifications for the unit.
Diagram and explanation of communication wiring for different models.
Visual representation of the terminal board connections.
Setting network addresses for indoor and outdoor units.
Using DIP switches to set the unit's refrigeration capacity.
Explanation of the function of mainboard DIP switches.
Settings for the SW2 switch related to unit shutdown and fan operation.
Settings for the SW5 switch related to temperature compensation.
Settings for the SW6 switch related to display panel and auto air blow.
Settings for the SW7 switch related to network configuration.
Guidance on installing branch pipes horizontally or vertically.
Points to confirm before performing the test operation.
Steps and checks for conducting the unit's test operation.
