EasyManuals Logo

Midea D10-20VD User Manual

Midea D10-20VD
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
7
(Fig.7)
4. METHODS OF USING
NOTE
During normal operation, the inlet valve shall be always kept open.
First, open any one of the outlet valves at the outlet of the water heater, then, open the inlet valve.
The water heater gets filled with water. When water flows out of the outlet pipe it implies that the
heater has been filled fully with water, and the outlet valve can be closed.
Insert the supply plug into the socket.
If the indicator lights up, the thermostat will automatically control the temperature. When the water
temperature inside the heater has reached the set temperature, it will switch off automatically,
when the water temperature falls below the set point the heater will be turned on automatically to
restore the heating.
Rotate the knob according to the marking on the knob to increase or decrease the setting
temperature.
The “White (up)” LED and “White (down)” LED remain ON while there is power to the system. The
green LED will turns off when the water temperature reaches the user setting, at the end of the
heating phase.
1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Midea D10-20VD and is the answer not in the manual?

Midea D10-20VD Specifications

General IconGeneral
BrandMidea
ModelD10-20VD
CategoryWater Heater
LanguageEnglish

Related product manuals