Fig.11
Sleep wind
Press the “mode” key to select the sleep wind, then press the “speed” repeatedly
to choose 3 speed.
6. “ ” SILENCE KEY
In the state of non-silence, press silence button, the fan would be in silent state and
the silence icon is lightened, while the indicator icons of the other wind types and
wind levels would turn off. In silent state, press wind type button, blast volume + and
– buttons, there would be no response, while other buttons could respond normally.
Press silence button again to quit and the fan would return to the previous working
state. The silence icon turns off and 00 is displayed on the digital screen.
b. BATTERIES
(battery not included in the packing)
(1) Slide the battery compartment Cover.
(2) Insert the batteries, and make sure that the
batteries are placed as shown in the Fig.10.
(3) Slide back the battery cover.
NOTES: Use manganese or alkaline batteries of
type "AAA". Do not use rechargeable batteries.
c. BATTERY WARNING AS BELOW
1. “Do not dispose of batteries in fire, batteries may
explode or leak.”
2. -Do not mix old and new batteries.
3. -Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
d. REMOTE CONTROLLER OPERATION
Point the remote controller at the receptor on body of the fan and press the desired
button. The remote controller will work at distances of up to roughly five meters and
the angle of 30 degree included between right and left from the receptor.
The batteries must be removed from the remote controller before it is scrapped and
that they are disposed of safely.
e. OVERHEAT PROTECTION OF THE MOTOR
The windings of the motor have a thermal-fuse that burns out and the fan switches
off and temperature of the motor is no longer going up so that plastic parts of the fan
don’t subject to deformation so far so to be burned by the overheat if the motor is
overheat for any unexpected reason.
5
AAA Battery, 1.5v
To Next Page
Loading...
