Midea FS40-15FR

Fig.12
OPERATING INSTRUCTION
I. Remote Controller (Fig.10)
a. KEY INSTRUCTION
1. “ ” ON/OFF KEY
The “ ” key is for switching on the fan .The fan will
be started at normal wind.
Press the “ ” key if the fan needs to switch off.
2. “ ” SPEED KEY
When the fan started, press this key repeated, the fan will work with “0-1-2-3(Off-
Low-Medium-High)” circulatory.
3. “ ” TIMER KEY
When this key is touched repeatedly or kept in pressed state, the time to be set for
air delivery increased step by step of each 0.5 hour and sums to 7.5 hours in 15 steps.
For instance, if the fan operation is required to be set for 5.5
hours, this key must be touched repeatedly so that the pilot
lamps for 0.5, 1 and 4 hours lighten together. It means that
the set time is 0.5+ 1+ 4= 5.5 hours.
The time setting indicated by the pilot lamp will decrease
gradually by a unit of 0.5 hour.
Don’t press the TIMER key when the fan is required to operate
continuously. At the moment all pilot lamps don’t light.
4. “ ” OSC KEY
After the fan is started, press this key to oscillate the fan, and
stop the oscillation at desired direction by pressing again. By
rotating the fan head by hand, you can get wider oscillation angle.
5. “ ” MODE KEY
Press this key to select mode. The sequence is normal, natural and sleep when this
key being touched repeatedly or continuously. The light can indicate mode state.
Normal wind
Press the “mode” key to select the normal wind, then press the “speed” repeatedly
to choose 3 speed.
Natural wind
Press the “mode” key to select the natural wind, then press the “speed” repeatedly
to choose 3 speed.
Fig.10
4