Do not, under any
circumstances, cut,
remove, or bypass
the grounding prong.
Power supply cord
with 3-prong grounding plug
and current detection device
Grounding type wall
receptacle
WARNING
NOTE:
The power supply cord with this air 
conditioner contains a current detection 
device designed to reduce the risk of fire.
Please refer to the section Operation
of Current Device for details.In the event 
that the power supply cord is damaged, 
it cannot be repaired-it must be replaced 
with a c  ord f rom t he P roduct M  anufacturer.  
Avoid fire hazard or electric shock. Do not
use an extension cord or an adaptor plug. 
Do not remove any prong from the power 
cord. 
WARNING
For Your Safety
WARNING
Prevent Accidents
WARNING
Electrical Information
Do not store or use gasoline or other flammable vapors and liquids in the vicinity  
of this or any other appliance.
Operation of Cur rent Device
(Applicable to the unit adopts current detection 
device only )
The power supply cord contains a current device that senses 
damage to the power cord. To test your power supply cord do 
the following:
1. Plug in the Air Conditioner.
2. The power supply cord will have TWO buttons on the plug 
    head. Press the TEST button, you will notice a click as the 
    RESET button pops out.
3. Press the RESET button, again you will notice a click as 
    the button engages.
4. The power supply cord is now supplying electricity to the 
    unit. (On some products this it also indicated by a light on 
    the plug head.)
3
To reduce the risk of fire, electrical shock, or injury to persons when using your
air conditioner, follow basic precautions, including the following:
    Be sure the electrical service is adequate for the model you have chosen. This
    information can be found on the serial plate, which is located on the side of the
    the cabinet and behind the grille.
    If the air  conditioner i s t o b e in  stalled in  a w indow, yo  u w ill pr obably w ant to  cl ean  
    both sides of  the g  lass f irst. I f th  e w indow is  a tri ple-track ty pe w ith a  sc reen pa  nel
    included, remove the screen completely before installation.
    Be sure the  air c  onditioner h as b een s ecurely a nd c orrectly in stalled a ccording to 
    the installation instructions in this manual. Save this manual for possible future
    use in removing or installing this unit.
    When handling the  air  conditioner,  be  careful  to  avoid  cuts f rom s  harp m  etal f ins
    on front and rear coils. 
 
The complete electical rating of your new room air conditioner is stated on the 
serial plate. Refer to the rating when checking the electrical requirements.
     Be sure the air conditioner is properly grounded. To minimize shock and fire 
     hazards, proper grounding is important. The power cord is equipped with a 
     three-prong grounding plug for protection against shock hazards.
     Your air conditioner must be used in a properly grounded wall receptacle. If the 
     wall receptacle you intend to use is not adequately grounded or protected by a 
     time delay fuse or circuit breaker, have a qualified electrician install the proper 
     receptacle. Ensure the receptacle is accessible after the unit installation.
     Do not run air conditioner without side protective cover in place.This could 
     result in mechanical damage within the air conditioner.
 Do not use an extension cord or an adapter plug.
IMPORTANT SAFETY INSTRUCTIONS
    Do not use this device to turn the unit on or off.
 Always make sure the RESET button is pushed in for 
    correct operation.
    The power supply must be replaced if it fails reset when 
    either the TEST button is pushed, or it cannot be reset. A 
    new one can be obtained from the product manufacturer.
    If power supply cord is damaged, it cannot be repaired. It 
    MUST be replaced by one obtained from the product 
    manufacturer. 
NOTE:
NOTE:This air conditioner is designed to be operated 
            under condition as follows:
Cooling 
operation
Outdoor temp: 
Indoor temp: 
Heating 
operation
Outdoor temp: 
O
O
23-76 F/ C-5-24
Indoor temp: 
O
32-80 F/
O
0-27 C
O O O O
64-109 F/18-43 C (64-125 F/18-52 C 
for special tropical models)
O
62-90 F/
O
17-32 C
Note: Performance may be reduced outside of these 
operating temperatures.