9
Ice Maker
8
Then use the needle nose pliers or other tools to remove the sealed
thermal insulation foam strip in the labeled sewer tube from the
water hole.
9
Take out the water tube connector, the sealing silicone piece, the
long water supply tuber and the white head screw from the
accessories. Position the silicone piece by aligning the notch to
x it on the connector, then insert one end of the water supply
tube into the quick change sealing ring at the bottom of the
connector and tighten it. Finally, insert the whole material into the
water inlet on the back of the box, and x the water tube connector
on the box with the long screw in the accessory package.
Clear foam strip
Sealing
silicone
piece
Water tube
connector
Water tube
To Next Page
Loading...