10
10
Ice Maker
Take out two plastic clamps from the accessories to x the long
water supply tube, x the water tube clamp with screws to the
embedded positioning hole on the back of the refrigerator,
and tighten the screws.
11
Take out the water valve from the accessories, connect the box
terminal with the water valve terminal, use the plastic box and the
box cover in the accessory bag to assemble and close the terminal
connection, use screws to connect the box with the box cover and
tighten these screws (the terminal installation box and the box
cover can be optionally installed, which does not aect the ice
making function).
Install the box
cover and
tighten it with
screws
Wiring harness
plug
Water supply tube
Plastic clamp
To Next Page
Loading...