EasyManua.ls Logo

Midea JL1566S-UF

Midea JL1566S-UF
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Service Manual_2018-V1.0
22
The packaging material used is recyclable; we recommend that you separate plastic, paper and cardboard and
give them to recycling companies. To help preserve the environment, the refrigerant used in this
product is R134a (Hydrofluorocarbon -HFC), which does not affect the ozone layer and has little
impact on the greenhouse effect. According to WEEE (Waste of Electrical and Electronic Equipment) guidelines,
waste from electrical and electronic devices should be collected separately. If you need to dispose of this
appliance in the future, do NOT throw it away withthe rest of your domestic garbage. Instead, please take the
appliance to he nearest WEEE collection point, where available.
the water dispenser will be installed.
5. Fix the bracket on the floor by screw tightly.
6. Tighten the screw.
WARNING! To avoid a hazard due to instability of the appliance, it must be fixed in
accordance with the instructions.
5. Trouble shooting
5.1 Simple troubleshooting
In case of failure, please carry out inspection according to the requirements below. If
unresolved, please contact the local service agency.
Failure
Cause
Solution
Small water flow
low water pressure
Check the booster pump or water inlet
Filter not replaced in
time ,beyond the use time
Please contact the local service
agency to replace the filter
Unsuitable
Water
temperature
Power supply not put
through
Please switch on power supply
Over consumption of water
in a short time
Just wait a moment, and water is
available again
Corresponding functions
not started
Press a corresponding function key to
start the function
Water leakage
Pipe not connected
Inspect the connector to connect

Related product manuals