3
Operating Manual
Note
Water adding in water tank and instructions for disassembly and washing
• Please clear the water collected at the bottom of the water tank when the machine is idle.
• When adding water and cleaning, the power plug should be unplugged.
• Before the start of the machine, a guarantee must be provided that the pump module is
fixed in place, and if the pump module is placed at random, the product may be humidified abnormally.
• There are two water adding ways:
① The half of the water in the water tank should be pumped out, the water pump module
should not be disassembled, and the water should be directly added.
② The water chestnut module should be separated, the water in the water tank should be pumped out
completely, and then the water should be added or the water tank should be cleaned.
1 The water tank buckle should be
unlocked to the horizontal state
2 The half of the water in the water tank should
be pumped out(the water tank should be pushed
after the water is added)
3 The water tank should be separated from
pump module (including water tube) by
turning the knob with a hand (90 degrees
counterclockwise)
4 The water tank should be cleaned and
the water should be added after the water
tank is slowly pulled out.
To Next Page
Loading...
Need help?
General
