Page 10
Operating
Instructions
COOL operation
• Press the “MODE” button until the “COOL”
indicator light comes on.
• Press the adjust buttons Up (
) or Down ( )
to select your desired room temperature.
The temperature can be set within a range of
60°F~86°F/16°C~30°C.
• Press the “FAN SPEED” button to choose the fan
speed.
HEAT operatio
(Only For Heat Model)
n
• Press the “MODE” button until the “HEAT”
indicator light comes on.
• Press the ADJUST buttons Up (
) or Down ( )
to select your desired room temperature.
The temperature can be set within a range of
60°F~86°F/16°C~30°C.
• Press the “FAN SPEED” button to choose the fan
speed.
• When entering heat mode, the fan may start
slower than expected. For some models, the fan
speed cannot be adjusted while in HEAT mode.
DRY operation
• Press the “MODE” button until the “DRY”
indicator light comes on.
• While in this mode, you cannot select a fan
speed. The fan
motor operates at AUTO speed.
• Keep windows and doors closed for the best
dehumidifying effect.
AUTO operation
• When you set the air conditioner to AUTO mode,
it will automatically select cooling, heating (Heat
models only) or fan only operation depending
on what temperature you have selected and the
current room temperature.
• The air
conditioner will control room temperature
automatically according to the temperature point
set by
you.
• Under AUTO mode, you cannot select the fan
speed.
FAN operation
• Press the “MODE” button until the
”FAN“ indicator light comes on.
• Press the “FAN SPEED” button to
choose the fan speed. The temperature
cannot be adjusted.
TIMER: Auto Start/Stop Operation
• When the unit is on, pressing the
Timer button will initiate the Auto stop
program.
• When the unit is off, press the Timer
button to initiate the Auto start program.
Pressing it again within five seconds will
initiate the Auto stop program.
• Press or hold the Up (
) or Down ( )
button to change the Auto time by 0.5
hour increments, up to 10 hours, then
at 1 hour increments up to 24 hours.
The control will count down the time
remaining until start.
• The system will automatically
revert back to display the previous
temperature setting if there is no
operation within 5 seconds.
• Turning the unit ON or OFF at any time
or adjusting the timer setting to 0.0
will cancel the Auto Start/Stop timer
program.
• Should a malfunction occur, the Auto
Start/Stop timed program will also be
cancelled.
Operating Instructions
Where the xx represents 2 numbers.
The display will alternate displaying the two
letter combination and the two
number combination to identify the error.
When an error occurs, restart the unit. Ifthe
error code still appears when the unit
restarts, unplug the power cord andcontact
customer service at 1-866-646-4332.
NOTICE
P1
-
Bottom tray is full - Connect the drain hose
and drain the collected water away. If
protection code repeats, call for service.
The LED Display will also show any errorcodes
when they occur. Error codes will app
ear in the
following format:
Ehxx, Ecxx, Elxx, PCxx, PHxx, PLxx.