Page 22
REMOTE CONTROL AND APP INSTRUCTIONS
Handling the Remote Control
Inserting and Replacing Batteries
• The air conditioner will not operate if curtains, doors
or other materials block the signals from the remote
control to the unit.
• Prevent any liquid from spilling onto the remote
control. Do not expose the remote control to direct
sunlight or heat.
• If the infrared signal receiver on the portable air
conditioner is exposed to direct sunlight, the air
conditioner may not function properly. Use curtains
to prevent the sunlight from falling on the receiver.
• If other electrical appliances react to the remote
control, either move these appliances or consult
your local dealer.
CAUTION
Remote Control
and App
Instructions
LOCATION OF THE REMOTE CONTROL
Use the remote control within a distance of 26 ft. (8m)
from the air conditioner, pointing it towards the unit.
The unit will beep when it receives a signal.
26 ft (8 meters)
Your air conditioning unit may come with
two batteries AAA (some units). Put the
batteries in the remote control before use.
1. Slide the back cover from the remote
control downward, exposing the
battery compartment.
2. Insert the batteries, paying attention
to match up the (+) and (-) ends of the
batteries with the symbols inside the
battery compartment.
3. Slide the battery cover back into place.
BATTERY NOTES
For optimum product performance:
• Do not leave batteries in the remote control if
• Do not mix old and new batteries, or batteries
you don’t plan on using the device for more
than 2 months.
To Next Page
Loading...
