Service manual for Washing Machine
-------------------------------------------------------------------------------------------------------------------------------------------------------
－ 16 －
leveling feet unnecessarily, it may cause abnormal vibration of the washing machine.
STEP 5: Powering your washer
Plug the power cord into a 3-prong, well grounded 120Volt 60Hz approved electrical outlet protected by a 15-
amp fuse or comparable circuit breaker.
Your washer is grounded through the third prong of the power cord when plugged into a 3-prong grounded
electrical outlet.
STEP 6: Running a test cycle
Run a test cycle as following to check if your washer is properly installed.
1. Load about 6 pounds of laundry into the tub.
2. Select the Cycles to turn on your washer.
3. Select the cycle by turning the.
4. Press the button to start the test cycle.
5. The washer should not rock or vibrate excessively when water is supplied or when washing or spinning, and
should drain well during the spin cycle.
If water leaks while water is being supplied or drained, check the water connections. Refer to the “Connect
the water hose”and “Connect the drain hose”section for instructions.
If the washer rocks and vibrates excessively, level your washer again. Refer to the“Leveling your washer”
section for instructions.
To Next Page
Loading...
