32
Declaration of conformity
FCC ID: 2ADQOMDNA21
IC: 12575A-MDNA21
This device complies with Part 15 of the FCC Rules and Industry Canada’s licence exempt
RSSs.
Operation is subject to the following two conditions:
This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference in a residential installation. This 
equipment generates, uses and can radiate radio frequency energy and, if not installed 
and used in accordance with the instructions, may cause harmful interference to radio 
communications. However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the 
user is encouraged to try to correct the interference by one or more of the following 
measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
   receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Hereby, we declare that this AC is in compliance with the essential requirements and 
other relevant provisions of RE Directive 2014/53/EU. A copy of the full DoC is attached 
(European Union products only).
Only operate the device in accordance with the instructions supplied. Changes or 
could void the user's authority to operate the equipment.This device complies with FCC 
radiation exposure limits set forth for an uncontrolled environment. In order to avoid the 
possibility of exceeding the FCC radio frequency exposure limits, human proximity to the 
antenna shall not be less than 20cm (8 inches) during normal operation.
(1) This device may not cause interference;and
(2) This device must accept any interference,including interference that may cause 
undesired operation of the device.
NOTE: