d) Using the different functions
Timer
To use the timer, press the timer button (3). The digital screen will indicate « 0 : 00 ».
Press on the +/- pads to adjust the cooking time. Each pressure increases or decreases the
time of1minute. If you maintain the button longer, the time will increase or decrease by
by increments of 10 minutes. The timer can be set from 1 minute to 180 minutes. Once
the time is set, the digital screen will flicker during 5 seconds before heating. To cancel
the timer function, press again on the timer butt
on Only Warm and Simmer button can
use timer button.
(3).
Keep warm mode
When the appliance is in operation, press on the Keep warm button (1) if you want to keep
warm your preparation. The appliance will set automatically on the lowest power and will
stop after 120 minutes. To set again the power, press directly on the +/- buttons.
Simmer mode
To use this mode, press on the Simmer button (2). A lamp lights up. The simmer cooker
entering the simmer state, the default power level shall be level 2. Under this mode, the
power cannot be adjusted. When press “+” or “-“ or slider again, the induction
cooker
entering the power state.
Fry mode
To use this mode, press on the Fry button (4). A lamp lights up. The default power level
shall be level 10. When press “+” or “-“ or slider again, the induction cooker entering the
power state.
Boil mode
Boil mode is for boiling water. To use it, press on the Boil button (5). A lamp lights up. The
default power level shall be level 10. In this mode, the default working time is 30 minutes.
Note
: It is recommended to put water that occupies 30% to 80% of the pot capacity when
boiling water.
Boost mode
The boost button (6) allows obtaining directly the highest power level. By pressing again the
boost button
(6) the appliance will go back to the power of origin.
Child lock mode
To lock the control pads during cooking, press on Child lock button (10).The indicator «Loc
» will appear on the screen. In this case, only the On/Standby button
(7) can be used to
9