Installation
3.6.3
①
Select the position of installation hooks according to the hook holes positions showed in upper picture.
Drill four
expansible hooks (fittings).
②
Install the tapping screws onto the wall.(Refer to picture below)
3.6.4
①
Remove the side board and the grille.
Install the pendant bolt
①
Ceiling installation
Select the position of installation hooks according to the hook holes positions showed in upper picture.
Drill four holes of Ø12mm, 45~50mm deep at the selected positions on the ceiling. Then embed the
expansible hooks (fittings).
②
Wall-
mounted installation
Install the tapping screws onto the wall.(Refer to picture below)
3.6.4
Ceiling installation (The only installation method for the unit with drain pump)
Remove the side board and the grille.
Install the pendant bolt
Ceiling installation
Select the position of installation hooks according to the hook holes positions showed in upper picture.
holes of Ø12mm, 45~50mm deep at the selected positions on the ceiling. Then embed the
expansible hooks (fittings).
mounted installation
Install the tapping screws onto the wall.(Refer to picture below)
Install the main bod
Ceiling installation (The only installation method for the unit with drain pump)
Remove the side board and the grille.
Select the position of installation hooks according to the hook holes positions showed in upper picture.
holes of Ø12mm, 45~50mm deep at the selected positions on the ceiling. Then embed the
expansible hooks (fittings).
Install the tapping screws onto the wall.(Refer to picture below)
Install the main bod
y
Ceiling installation (The only installation method for the unit with drain pump)
Remove the side board and the grille.
Select the position of installation hooks according to the hook holes positions showed in upper picture.
holes of Ø12mm, 45~50mm deep at the selected positions on the ceiling. Then embed the
Install the tapping screws onto the wall.(Refer to picture below)
Ceiling installation (The only installation method for the unit with drain pump)
Remove the side board and the grille.
Select the position of installation hooks according to the hook holes positions showed in upper picture.
holes of Ø12mm, 45~50mm deep at the selected positions on the ceiling. Then embed the
Install the tapping screws onto the wall.(Refer to picture below)
Ceiling installation (The only installation method for the unit with drain pump)
Select the position of installation hooks according to the hook holes positions showed in upper picture.
holes of Ø12mm, 45~50mm deep at the selected positions on the ceiling. Then embed the
Install the tapping screws onto the wall.(Refer to picture below)
Ceiling installation (The only installation method for the unit with drain pump)
Select the position of installation hooks according to the hook holes positions showed in upper picture.
holes of Ø12mm, 45~50mm deep at the selected positions on the ceiling. Then embed the
Ceiling installation (The only installation method for the unit with drain pump)
Indoor unit installation
Select the position of installation hooks according to the hook holes positions showed in upper picture.
holes of Ø12mm, 45~50mm deep at the selected positions on the ceiling. Then embed the
Indoor unit installation
209
Select the position of installation hooks according to the hook holes positions showed in upper picture.
holes of Ø12mm, 45~50mm deep at the selected positions on the ceiling. Then embed the
holes of Ø12mm, 45~50mm deep at the selected positions on the ceiling. Then embed the
To Next Page
Loading...
Need help?
General
