10
EN
Wireless network setting-AP configuration
• Please start AP mode before connecting to the mobile app. Whether in the
locked or unlocked state, press and hold the mode button for 3s to force
the refrigerator wireless module to set to AP mode, and then the temperature
display area will display AP. After the module is successfully congured to
enter the AP mode, it will automatically exit the AP mode, and the temperature
display area will return to normal temperature display. After setting the AP
mode, if the module is not congured successfully for 10s, it will forcibly exit
the AP mode and restore the normal temperature display.
Storage upon power failure
• In case of power failure, the instant working state will be locked and
maintained till re-electrication.
Opening warning and alarm control
• when open the refrigerator doors, the opening music will play. If the door is
not closed in two minutes, the buzzer will sound once every minute until the
door is closed. Press anyone button to stop the buzzer alarm.
ATTENTION
Disable the door opening tone: Press and hold thecombination key
and for 3 seconds
to disable or enable the door opening tone (the tone is enabled by default).
Disable the door opening alarm sound: Not possible
Error code
• The following warnings appearing on the display indicate corresponding faults
of the refrigerator. Though the refrigerator may still have cold storage function
with the following faults, the user shall contact a maintenance specialist for
maintenance, so as to ensure optimized operation of the appliance.
Fault Code Fault Description
E1 Temperature sensor failure of refrigerating chamber
E2 Temperature sensor failure of freezing chamber
E5 Freezing defrost sensor detection circuit error
E6 Communication error
E7 Ambient temperature sensor error
To Next Page
Loading...
Need help?
General
