EasyManuals Logo

Midea MDW 12E4 User Manual

Midea MDW 12E4
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
25
Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise
the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
1. Open the door and switch on the appliance.
2. Within 60 seconds after the appliance was switched on press the Program
button for more than 5 seconds to enter the water softener setting mode.
3. Press the Program button again to select the proper setting according to your
local water hardness, the setting will change in the following sequence:
H3->H4->H5->H6->H1->H2->H3;
4. Without operation in 5 seconds or press the Power button to complete the setup
and exit the setup mode.
1 dH=1.25 Clarke=1.78 ) fH=0.178mmol/l
WATER HARDNESS
Water softner level
1)
1)
0 - 5
6 - 11
12 - 17
18 - 22
23 - 34
35 - 55
0 - 9
10 - 20
21 - 30
31 - 40
41 - 60
61 - 98
0 - 6
7 - 14
15 - 21
22 - 28
29 - 42
43 - 69
0 - 0.94
1.0 - 2.0
2.1 - 3.0
3.1 - 4.0
4.1 - 6.0
6.1 - 9.8
H1: Rapid Light bright
H2: 90min Light bright
H3: Rapid, 90min Light bright
H4: ECO Light bright
H5: ECO, Rapid Light bright
H6: 90min, ECO Light bright
Regeneration occurs
every X program
sequence
Salt
consumption
(gram/cycle)
No regeneration
10
5
3
2
1
0
9
12
20
30
60
German
dH
French
fH
British
Clarke
Mmol/l
Every cycle with a regeneration operation consumes additional 2.0 litres of water, the
energy consumption increases by 0.02 kWh and the program extents by 4 minutes.
The factory setting: H3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Midea MDW 12E4 and is the answer not in the manual?

Midea MDW 12E4 Specifications

General IconGeneral
BrandMidea
ModelMDW 12E4
CategoryDishwasher
LanguageEnglish

Related product manuals