An issue
Possible causes Solution
Spilled agent
for rinsing.
Always wipe up spilled rinse aid
immediately.
Stained
the inside of the washing machine
You used a detergent
with dyes.
Choose a detergent without dyes.
White deposits in
interior
washing machines
Hard water minerals.
Clean the inside of the washing
machine with a damp soft cloth and
dishwashing detergent. Wear rubber
gloves. Never use anything other
than dishwashing detergent to avoid
excessive foam.
On the dining table
accessories are
noticeable stains
from rust
That accessory is not
corrosion resistant.
Avoid washing objects that are not resistant to
corrosion in the washing machine.
You have not started
program after
addition of salt.
Into the wash cycle
there were traces of salt.
After adding salt, always start the washing
program with an empty washing machine,
without selecting the Turbo function (if your
model has it).
Loose lid
softener compartment
Check the cover.
Knocking in
interior
washing machines
The sprinkler hits o
dishes in the basket.
Stop the program and remove
the dishes blocking the sprayer.
Rattling in
interior
washing machines
There are no dishes
attached.
Stop the program and arrange the
dishes.
Knocking in the pipes
for water
The reason for this may be
the place of installation or
the cross-section
pipes.
This does not affect the operation of the
washing machine. If you are not sure,
contact a professional plumber.
The dishes are not clean The dishes are not correct
set up.
See PART TWO, "Preparing and putting
dishes in the washing machine".
The program was not
strong enough.
Choose a more intensive program.
27
To Next Page
Loading...
