• Sit the motor unit on a dry, firm, level surface.
• Route the cable so it doesn’t overhang, and won’t trip or catch.
• Lower the jug on to the motor unit, then turn the jug clockwise, to lock it in place.
• Remove the lid.
• Put the ingredients into the jug – don’t fill past the max mark.
• Put the lid on the jug.
OPERATION INSTRUCTIONS
08
In Brief
• Check that the speed control is set to 0.
• Put the plug into the power socket (switch it on, if it’s switchable).
Power Up
• Turn the speed control clockwise (1 = low, 2 = high).
• Turn it back to 0 to turn the motor off.
• Use low speed (1) for lighter applications, using mainly liquid ingredients, and high
speed (2) for heavier applications, using mainly solid ingredients.
• Turning it anti-clockwise to P will give you a short burst at high speed, for more precise
control. In this direction, the control is spring-loaded. When you let go, it’ll return to 0.
Speed Control
• Lower the jug on to the motor unit, then turn the jug clockwise, to lock it in place.
• Pull the lid up and off the jug - it’s stiff, because of the seal.
• Put the ingredients into the jug - don’t fill past the max mark.
• Put the lid on the jug, and push it down to seal it.
• Align the pips on the cap with the slots in the hole, fit the cap in the hole, and turn
clockwise. Don’t rut the blender without the cap.
• To add ingredients while the motor is running:
a)turn the cap clockwise to unlock it, and lift it off.
b) add the ingredients via the hole.
c)replace the cap and turn it anti-clockwise to lock it.
• Turn the jug anti-clockwise to unlock, and lift it off the motor unit.
• Recipe:Soaked carrots 600g and water 900g,after at max speed setting,operation
time: 2 min.
Using The Blender
• Start with half to threequarters of a cup of ice, or 4 to 6 cubes, and add 15mL (1 tbsp)
of water.
• Put the lid on the blender, then turn the speed control to P for a second or so, check
the state of the ice, and repeat till the ice is the consistency that you need.
Crushing Ice
To Next Page
Loading...