Leveling circle
Washer is level – the
water touches the
leveling circle all
the way around.
Washer not level - the
water does not touch
the leveling circle all
the way around.
3. If your washer is not level, carefully tilt your washer just enough to
adjust the leveling feet on the bottom front of your washer. Extend the
feet only as much as is necessary. If the feet are extended too much,
your washer may vibrate.
Plug the power cord into a well-grounded, 3-prong, 120 Volt 60 Hz
approved electrical outlet, protected by a 15-amp fuse or comparable
circuit breaker. Your washer is grounded through the third prong of the
power cord.
Power on
25
loosen lock
Adjustable legs
Safety
Instructions
Features
Operation
Requirements
Installation
Instructions
Washer Use
Washer Care
Troubleshooting
To Next Page
Loading...
Need help?
General
