Page 26
Operating
Instructions
(With Remote)
How to Use Use the Advanced Fuctions
SHORTCUT Function
SWING Function
Note:
ON/OFF
TEMP
SHORT
CUT
TIMER
ON
TIMER
OFF
MODE
FAN
LED
ION
SLEEP
FOLLOW
SWING
ME
SLEEP Function
The SLEEP function is used to decrease
energy use while you sleep (and don t need
the same temperature settings to stay
comfortable). This function can only be
activated via remote control.
Used to stop or start louver movement and set the
desired up/down air flow direction. The louver
changes 6 degrees in angle for each press (some
models without). If keep pushing more than 2
seconds, the louver auto swing feature is activated.
The FOLLOW ME function enables the
remote control to measure the
temperature at its current location.
When using AUTO, COOL, or HEAT
functions, measuring ambient
temperature from the remote control
(instead of from the indoor unit it self)
will enable the air conditioner to
optimize the temperature around you
and ensure maximum comfort.
1. Press FOLLOW ME button to activate
function. The remote control will send
temperature signal to the unit every
three minutes.
2. Press FOLLOW ME button again to
turn off this function.
Used to restore the current settings or resume
previous settings.
Push this button when remote controller is on,
the system will automatically revert back to the
previous settings including operating mode,
setting temperature, fan speed level and sleep
feature (if activated).
If pushing more than 2 seconds, the system will
automatically restore the current operation
settings including operating mode, setting
temperature, fan speed level and sleep feature
(if activated).
The SLEEP function is not
available in FAN or DRY mode.
FOLLOW ME Function
NOTES
• Buttons design is based on typical model and might be slightly different from the
actual one you purchased, the actual shape shall prevail.
• All the functions described are accomplished by the unit, if the unit has no this
feature, there is no corresponding operation happened when press the relative
button on the remote controller.
To Next Page
Loading...
