•
•
•
12
or
SET function
Press the SET button to enter the function setting, then press SET button or TEMP or TEMP
button to select the desired function. The selected symbol will flash on the display area, press
the OK button to confirm.
To cancel the selected function, just perform the same procedures as above.
Press the SET button to scroll through operation functions as follows:
FRESH function ( ) (some units) :
AP function ( ) (some units) :
When the FRESH function is initiated, the Ionizer/Plasma Dust Collector(depending on models) is
energized and will help to remove pollen and impurities from the air.
Choose AP mode to do wireless network configuration. For some units, it doesn’t work by
pressing the SET button. To enter the AP mode, continuously press the LED button seven times
in 10 seconds.
Fresh ( ) I Sense ( ) AP mode( )
[ ]: If your remote controller has I Sense button, you can not use the SET button to select
the I sense feature.
*
*
To Next Page
Loading...
Need help?
General
