MCAC-UTSM-201707 Midea Tropical R410A High Efficient Duct Technical Manual 50Hz
124
Over fasten the screw will lead to deformation of back cover.
Neaten the wires of the wired controller
There are three positions of signal wire outlet around the wired controller, when the wired
controller directly is installed on the flat wall.
When the wired controller is stalled with electrician box, the back cover of wired controller is
already reserved one hole for wire outlet. It is also available for the shielded wire passing by
the wall.
Avoid the water enter into the wired controller, use trap and putty to seal the connectors of
wires during wiring installation. When under installation, reserve certain length of the
connecting wire for convenient to take down the wired controller while during maintenance.
To Next Page
Loading...
Need help?
General
