● Check before turning on the machine
1.
Check if the power wire is under good condition.
2.
The product adopts 220V~240V 50Hz AC power supply, before use,
please confirm if the rated current of the power socket meets the local
requirements, otherwise, please replace it with the qualified socket.
● Put the machine on the flat place
Please put the heater on the flat place, at least the surface below the base
of the heater must be flat.
● Tempe
rature Control Knob
Insert the plug into the power socket, then turn the Temperature Control
knob clockwise, when hearing the “popping ”sound
● Power Selection Knob
Turn the Power selection knob to select between 5 functions: II 2000W
(High+Fan on), I
1200W (Low+Fan on), 0(Off), I
1200W (Low+Fan off), I
2000W (High+Fan off).
● Turn off the Heater
A.
Turn the Power selection knob to OFF position.
B.
Turn the Temperature Control knob anticlockwise to the initial position.
C.
Remove the power plug, store the heater after the entire machine has
become cool.
● Safety Protection
1.
Overheat protection: This heater includes an Overheat Protection System
that shuts the unit off if it overheats due to abnormal conditions. If this
occurs turn the heater “OFF”, unplug it, and inspect and remove any
objects on or adjacent to the heater. Allow it to cool for a few minutes,
plug it back in, and resume normal operat
ion.
(it means the
temperature controller is on), adjust the Temperature Control knob to the
desired temperature level.
To Next Page
Loading...
Need help?
General
