Need help?Do you have a question about the Midea NF20-18URB and is the answer not in the manual?
General| Type | Fan Heater |
|---|---|
| Heating Power | 2000 W |
| Power | 2000 W |
| Voltage | 220-240 V |
| Number of power levels | 2 |
| Overheat Protection | Yes |
| Tip-Over Protection | Yes |
| IP Rating | IP20 |
| Frequency | 50-60 Hz |
| Heating Modes | Low, High |
| Thermostat | Adjustable thermostat |
Warning: In order to avoid overheating, do not cover the heater.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person.
Appliance can be used by children aged 8+ and persons with reduced capabilities with supervision.
The heater must not be located immediately below a socket-outlet or near baths/showers/pools.
Some parts of this product can become very hot and cause burns. Particular attention is needed for children and vulnerable people.
This product should not be disposed of with household waste; recycle responsibly to promote sustainable reuse of material resources.
Press and hold the '≈' key to select between 4 functions: Fan only, Low, High Heat, 1200W (LOW), 2000W (HIGH).
Press and hold the 'A' key to set the temperature: 18°C, 21°C, 24°C, 27°C, 30°C.
Press the 'ON/OFF' key to turn off or remove the power plug after the machine has cooled.
Includes overheat protection and inversion protection that automatically cut off power.
Allows for easy transport from room to room.
To Next Page
