8.4.4 Auto-mode
The machine will choose cooling, heating or fan-only mode according to ΔT (ΔT =T1-Ts).
ΔT=T1-Ts Running mode
ΔT＞2℃
Cooling
-3≤ΔT≤2℃
Fan-only
ΔT<-3℃
Heating(for cooling only models, they will run at fan-only mode)
AC will run in auto mode in the below cases:
（1） Press the forced auto button.
（2） If AC is off, it will run in auto mode when timer on function is active.
（3） After setting the mode, AC will run in auto mode if the compressor keeps not running for 15
minutes.
8.4.5 Drying mode
8.4.5.1 The compressor is cycled running by 10 minutes on and then 5 minutes off. The indoor fan will
keep running at low speed.
8.4.5.2 In drying mode, if the room temperature is lower than 10 ℃, the indoor fan will run at breeze
while the compressor and outdoor fan will stop and not resume until room temperature exceeds 13 ℃.
8.4.5.3 The system protection is active in this mode.
8.4.6 Forced operation function
Press the touch button continually, the AC will run as below sequence:
Forced auto →Forced cooling →Off
Forced cooling mode:
The compressor and outdoor fan keep running and the indoor fan runs at low speed. After running for
30 minutes, AC will turn to auto mode with 24℃ setting temperature.
Forced auto mode:
The action of forced auto mode is the same as normal auto mode with 24℃ setting temperature.
When AC receives signals, such as switch on, switch off, timer on, timer off, mode setting, fan
speed setting, sleeping mode setting, follow me setting, it will quit the forced operation.
The forced operation function can not be memorized if power off.
To Next Page
Loading...
Need help?
General
