Need help?Do you have a question about the Midea Blanc ON-OFF Series and is the answer not in the manual?
General| Brand | Midea |
|---|---|
| Model | Blanc ON-OFF Series |
| Category | Air Conditioner |
| Language | English |
Essential safety guidelines to prevent injury, damage, and ensure proper operation.
Critical warnings regarding installation, electrical safety, handling, and environmental factors.
Lists the model names for indoor and outdoor units based on capacity.
Provides dimensions (W*D*H) for different indoor unit models.
Illustrates required clearances and space for the outdoor unit installation.
Specifies torque values for pipe connections to ensure secure and leak-free installation.
Guidelines for selecting appropriate power cord cross-sectional area based on appliance current.
Details standard pipe length, maximum elevation, and refrigerant amount for different models.
Step-by-step instructions for initial system installation, including leak testing and evacuation.
Procedure for adding refrigerant to a system that has been in use for an extended period.
Steps for collecting refrigerant and preparing for re-installation after indoor unit repair.
Procedures for system evacuation and refrigerant charging during outdoor unit repair re-installation.
Illustrates the electrical wiring connections for the indoor unit.
Shows the electrical wiring schematic for the outdoor unit components.
Defines abbreviations used for temperature sensors (T1-T5) in electronic functions.
Explains the indoor unit's digital display icons and their meanings during operation and diagnostics.
Details various protection mechanisms like time delay, sensor errors, current protection, and leakage detection.
Overview of different operating modes (Fan, Cooling, Heating, Drying) and special functions.
Lists error codes (E0-E7, EC, F2) displayed by the indoor unit and their corresponding LED status.
Provides step-by-step guidance for diagnosing and resolving common error codes and malfunctions.
Instructions on how to check temperature sensors by measuring resistance with a tester.
To Next Page
