both hands to make the bottom buckle
complete. Two ST3.5*13 screws were
respectively taken to tighten the bottom cover.
1. 将透明盖对应孔位安装到位；
2. 取一面贴对准缺口位及按键位粘贴摩平；
3. 分别取 3 颗 ST2.9*9.5螺钉将电路板紧固在
顶盖上并确认按键手感；
4. 将顶盖对应前后壳套入，使用双手压住顶
盖轻推使 顶 部 扣位完成卡到位并 取 1 颗
ST3.9*13 螺钉将顶盖紧固在后壳上。
1. Install the corresponding hole of the
transparent cover in place;
2. Take one side paste and apply it to the notch
position and key position.
3. Take 3 ST2.9*9.5 screws to fasten the circuit
board on the top cover and confirm the touch
of the key;
4. Insert the cover into the front and rear shell,
press the cover with both hands to make the
top buckle complete and put in place. Tighten
the cover on the back shell with a ST3.9*13
screw.
To Next Page
Loading...
