Tools Required:
Putty Knife Pliers
¼ inch Socket Wrench Needle Nose Pliers or Nut Driver
Adjustable Wrench Knife
Flat Screw Driver
1 Disconnect the unit from the electrical supply.
2 Remove ice tray rack from freezer.
3 Move the freezer shelf to the next position.
5
4
Carefully Remove the plugs / label from inside the freezer
compartment using a putty knife.
6 Peel away the label covering the ice-maker installation
hole.
7 Using a pair of needle nose pliers, remove the foam from
the hole.
8 Insert the water inlet tube into the small hole on the back of
the refrigerator. Rotate the hose while inserting until the flat
surface of the hose is secure against the back of the
refrigerator.
Plug
In order to remove the plug, you need to squeeze the two ends
and pull the plug out, or need to use the tools such as a flat
screw driver or needle nose plier
To Next Page
Loading...
Need help?
General
