Midea YL1633S - Install Water Bottle; Provide Electricity; Activate Heating & Cooling

Install water bole
1. Open cabinet door.
2. Place probe assembly on probe hanger.
3. Place fresh bole outside of cabinet.
4. Remove enre plasc cap from top of bole.
5. Clean outside of new bole with a cloth.
6. Place probe into bole.
7. Slide collar down unl it clicks in place.
8. Push head down unl tube hits boom of
bole.
9. Slide bole into cabinet and close door.
Provide Electricity
Plug cord into a properly grounded wall outlet.
At this me the pump will begin to move water
from the bole to the hot and cold tanks. It will
take up to 12 minutes to fill the tanks for the first
me. During this period the pump will run
connuously. This is normal.
Acvate Heang & Cooling
Noce: This unit will not dispense hot or cold water unl the switches
are acvated.
To acvate, push top side of power switches in to start heang and cooling
water.
- If you do not want to heat water, push boom side of red switch in.
- If you do not want to cool water, push boom side of green switch in.
4