Aenon:
1) The cleaning must be unber the guidance or professional staff.
2) The dispenser heats water to a temperature of approximately 185 F.
It can cause severe burns. Please operate it carefully.
The machine should be disinfected with a disinfectant according to the
instrucon manual of the disinfectant and then clean it with water(see
cleaning and draining instrucon) Generally this should be done every
three months.
3. Sanizing
Mix 4 liters water with 200g citric acid crystals, inject into the machine and make
sure the water can flow out of the hot water tap. Switch on the power and heat it
about 10 minute. 30 minutes later, drain off the liquidand clean it with water two
or three mes.Generally this should be done every six months.
Never disassemble this machine by yourself to avoid danger from damaging
machine.
4. To Remove Mineral Deposits:
To prevent the machine from swaying or falling,
Please install the bracket accordingly.
1-2. Loosen the screw of the le or right boom angle
Just as the picture shown
3.Use the screw to fix the bracket on the le or right
boom angle of the water dispenser.
4.Make a hole on the floor's surface where
The water dispenser will be installed.
5.Fix the bracket on the floor by screwing ghtly.
6. Tighten the screw.
WARNING! To avoid a hazard due to instability of the appliance, it must be
fixed in accordance with the instrucons.
G: MACHINE INSTALLATION
7
To Previous Page
Loading...
