6
H. MACHINE INSTALLATION
3. Sanitizing:
The machine should be disinfected with disinfectant separately bought
from drugstore or marketplace according to the instruction manual or
the disinfectant and the clean it with water( see cleaning and draining
instruction). Generally this should be done every three months.
4. To remove mineral deposits:
Mix 4 liters water with 200g citric acid crystals, inject into the machine
and make sure the water can flow out of the hot water tap. Switch on the
power and heat it about 10 minutes, 30 minutes later, drain off the liquid
and clean it with two or three times. Generally this should be done every
six months.
Never disassemble this machine by yourself to avoid danger from
damaged machine.
Instructions for installation:
1-2. Loosen the screw of the left or right bottom angle
just as the picture shown.
3. Use the screw to fix the bracket on the left or right
bottom angle of the water dispenser.
4. Make a hole on the floor’s or the desk’s surface
where the water dispenser will be installed.
5. Fix the bracket on the floor by screw tightly.
6. Tighten the screw.
WARNING! To avoid a hazard due to instability of the appliance, it
must be fixed in accordance with the instructions.
To Previous Page
Loading...
Need help?
General
