The packaging material used is recyclable; we recommend that you separate plastic, paper and
cardboard and give them to recycling companies. To help preserve the environment, the
refrigerant used in this product is R134a (Hydrofluorocarbon -HFC), which does not
affect the ozone layer and has little impact on the greenhouse effect. According to WEEE
(Waste of Electrical and Electronic Equipment) guidelines, waste from electrical and electronic
devices should be collected separately. If you need to dispose of this appliance in the future, do NOT
throw it away with the rest of your domestic garbage. Instead, please take the appliance to he nearest
4. Installation specification
4.1 Installation requirements
1. Keep this machine in place of dry and avoid direct
sunshine. Rear of the machine should be no more
than 25cm against from the wall. Never put the
machine on paper or foam, which may cause
unstable condition, Never put anything flammable
beside this machine.
2. The appliance is suitable for indoor use only.
4.2 Machine installation
1. Use the screw to fix the bracket on the hole of the
middle bottom of the water dispenser.
2. Make a hole on the floor’s (or the desk’s) surface
where the water dispenser will be installed.
3. Fix the bracket on the floor by screw tightly.
4. Tighten the screw.
WARNING! To avoid a hazard due to instability of the appliance, it must be fixed in accordance with the Instructions.
To Next Page
Loading...
Need help?
General
