Midland ALAN 42 MULTI - Page 7

ALAN 42 MULTI:
- Open the radio and locate the 4 jumpers in the centre of the PC board under the display:
- Work on the jumpers to get the required band:
- The bands : I, I2, d, d2, EU, EC, E, F, UK, are always active by Default, and in addition by acting
on the jumpers: S1, S2, S3, S6, it is possible to activate and isolate the bands: PL, PX, RU, SW,
according o to the following table:
Input Pin Select
Item
S6 S1 S2 S3
Result
0
0 0 0 0 All Band Active
1
0 0 0 1 Band PL Active
2
0 0 1 1 Band RU Active
3
0 1 0 0 Delete Band SW
4
0 1 0 1 Band PX Active
5
0 1 1 1 Band SW Active
6
1 0 0 0 Band PL, PX, RU, SW Disable
“1” = is Open circuit
“0” = is Short circuit