Midland Alan 52 Multi - Alan 52 Multi Technical Specifications

16
TECHNICAL SPECIFICATIONS
Channels .......................................... 40 FM (see the Frequency band chart)
Frequency Range ..................................................... 26.565 - 27.99125 MHz
Operating mode ............................................................. F3E (FM), A3E (AM).
Antenna impedance ..........................................................................50 Ohm.
Loudspeaker ...............................................................................8 Ohm 0.5W.
Microphone ............................................................................. condenser type
Power supply ....................................................................7.2 ÷ 13,2 nom 12V
Duty cycle ..................................................... 5% TX - 5% RX - 90% Stand-by
Dimensions ............................................................................... 30x70x77 mm
Weight ...................................................................................................190 gr
RECEIVER
Sensitivity at 10dB S/N ............................................0.5µV (AM), 0.25µV (FM)
Selectivity .............................................................................. more than 60dB
Squelch range ............................................................................0.25V-500µV
Audio output power........................................... 0.5W 8 ohm (10% distortion)
Distortion at 1000 µV .................................................................................3%
Audio frequency response .......................................................... 400-2400 Hz
Intermediate frequency .............................................................I° 10.695 MHz
.......................................................................................................II° 455 KHz
Spurious response................................................................ more than 60 dB
Current drain at stand-by ..................................................................... 100 mA
TRANSMITTER
RF Output Power ..................................................duty cycle 10% 4W AM/FM
Frequency Tolerance ...........................................................................0.005%
Harmonic Suppression ......................................................... more than 70 dB
Current Drain .......................................................................................900 mA
Modulation ..............................................................................AM 90% (± 5%)
............................................................................................... FM dev. 2.0KHz
All specications are subject to change without notice.
Hereby, CTE International declares that this product is in compliance with the essential
requirements and other relevant provisions of Directive 1999/05/EC
WARNING
Direct plug-in ac/dc power supply must be used for disconnecting the transceiver from the
mains; the desktop charger must be positioned close to the unit and easily accessible.