Midland BT2 Manual

5
UK
Description of the audio kit
The audio system includes two ultra-at stereo speakers and
two interchangeable microphones, which are both supplied
with a bracket and wire connection.
Fixing the stereo speakers. The two stereo speakers have
a Velcro/adhesive strip that aids their xing to your helmet.
Beware to not completely cover your ear with the speak-
ers, you must always be able to listen to the trafc sound
and indication.
The microphone can be xed onto the helmet in two ways:
Boom Microphone. Place the section with the Velcro/ad-
hesive strip between the padding and the rigid cover of the
helmet, so that the microphone is correctly positioned in front
of your mouth and that the white symbol is facing your mouth.
This type of microphone is suited for Open Faced and Flip
Front helmets.
Wire microphone. Using the Velcro/adhesive strip, place the
microphone inside the helmet in front of your mouth. This type
of microphone is more suited for Full Faced helmets.
The mini connector on the microphone allows you choose the
microphone that best suits the helmet you are using.
The audio kit must then be connected to the central jack of
the Midland BT2 Intercom unit using the “L” shaped connec-
tor. This connector is very exible and can be easily adapted
to most commercial helmets.
Description of the installation brackets
The Midland BT2 can be xed onto the helmet in two different
ways: By either using the plate with bi-adhesive strip, or the clamp.
These methods allow you to safely “x” the BT2 unit onto your hel-
met and to remove it at any time in order to recharge or store it.
Plate with bi-adhesive strip
The xing plate has a bi-adhesive strip on one of its sides. To
x the plate in place, clean the application area on the hel-
met surface, remove the bi-adhesive lm and place the xing
plate on the helmet by keeping it contact with the surface for
a few seconds.
Clamp
Using the Allen Key, loosen
the two screws on the clamp
and place the rear plate be-
tween the helmet padding
and the external rigid protec-
tion. Then, tighten the two
screws in order to rmly x
the clamp in place.
Fitting and removing your Midland BT2
The BT2 can be easily tted onto the helmet by sliding it
downwards so that it ts into the slot of the selected xing
device (plate with bi-adhesive strip or clamp).
BT2 is maintained in position thanks to the xing clip located
on the upper section (A).
To detach the BT2, simply press the xing clip and push the
unit upwards.
A

Midland BT2 Specifications

General

Brand	Midland
Model	BT2
Category	Intercom System
Language	English