CT590 user’s manual | 17
OFF: OFF
R-DCS: D023N-D754N (Normal DCS)
R-DCS: D023I-D754I (Inverse DCS)
Note: In CT590 there are 208 groups of normal and inverse DCS codes. This
function cannot be amended in channel mode.
Receiving CTCSS (R-CTCSS) - MENU No.11
As DCS codes, the CTCSS codes can be added to the channels for creating
new private channels.
Note: there are 50 groups of CTCSS tones. In channel mode the CTCSS tones
cannot be changed.
Transmitting DCS - (T-DCS) - MENU No.12
In this Menu you activate DCS codes in tx mode. You can choose between
normal R-DCS (D023N-D754N) and inverted R-DCS (D023I-D754I)
Note: the groups of DCS codes are 208. DCS codes cannot be changed in chan-
nel mode.
Transmitting CTCSS (T-CTCSS) - MENU No.13
In this Menu you can set a CTCSS tone in tx mode.
You can choose: OFF or CTCSS (67.0 to 254.1 Hz)
Note: there are 50 groups of CTCSS tones. In channel mode the CTCSS tones
cannot be changed.
Voice function (VOICE) - MENU No. 14
With this function, you activate a voice that informs you about any operation/
selection you are doing.
ANI-ID (ANI-ID) - MENU No.15
With this function you can set your ID-code. It can be programmed by the
proper programming software. You can edit up to 5 digits.
DTMFST (DTMFST) - MENU No.16
This function is not supported from serial number O17100001.
To Next Page
Loading...