18 | CT590 user’s manual
Signal code (S-CODE) - MENU No.17
This function is not supported from serial number O17100001.
SCAN Resume Mode (SC-REV) - MENU No.18
Thanks to this function, CT590 can SCAN in frequency or channel mode.
You can choose amongst three options:
TO - Time-operated SCAN
Whenever a signal is detected, the radio will suspend the SCAN for 5 seconds,
and then will continue to SCAN even if the signal is still present.
CO: Carrier-operated SCAN
Whenever a signal is detected, the radio will stop scanning. It will resume to
SCAN once the signal will disappear.
SE: Search SCAN
The radio will stop scanning once a signal is detected.
PTT-ID (PTT-ID) - MENU No.19
With this function you can decide when sending the ANI-ID code in tx mode.
You can choose amongst 4 possibilities.
OFF: press PTT to turn it o
BOT: the code is sent when you press the PTT
EOT: the code is sent when the PTT is released
BOTH: the code is sent when you press and release the PTT
Note: select ‘OFF’ when using in case of aecting the radio.
PTT ID delay (PTT-LT) - MENU No.20
In this MENU you can set the delay time (0-30ms) sending the PTT-ID.
Note: select ‘0’ in normal using.
Channel A Display Mode (MDF-A) - MENU No.21
This function is used to set the display mode of channel A.
Display modes:
FREQ.: Frequency + channel No.
CH: Channel number
NAME: Channel name
Note: Channel name mode must be set by the programming software. Up to three
numbers or characters can be edited.
To Next Page
Loading...